Download or view dropperHolder.frink in plain text format
/** This makes a 3-D model for a eyedropper holder with a hook that hangs
in a refrigerator. */
// The resolution of the object in voxels/length.
r = 254/in
// Configure these for your cap. Note that your slicer software may force
// minimum wall thicknesses that override these.
innerDiam = 24 mm
sidewallThickness = 1.5 mm
outerDiam = innerDiam + 2 sidewallThickness
topThickness = 2 mm
height = 46 mm + topThickness
holderWidth = 1.5 cm
holderDepth = 6 mm
holderHeight = 1 cm
// The holder that clips to the refrigerator shelf. This is a cuboid that
// reaches to the center of the cylinder (and will be cut out later.)
holder = callJava["frink.graphics.VoxelArray", "construct", [-holderWidth/2 r, holderWidth/2 r, -(outerDiam/2 + holderDepth) r, 0, (height-holderHeight) r, (height) r, true]]
// The channel inside the holder that goes over the shelf. Remove it from
// the holder.
channel = callJava["frink.graphics.VoxelArray", "construct", [-holderWidth/2 r, holderWidth/2 r, -(outerDiam/2 + 3.1 mm) r, (outerDiam/2) r, (height-holderHeight) r, (height-2 mm) r, true]]
holder.remove[channel]
// Outer main cylinder
c1 = callJava["frink.graphics.VoxelArray", "makeCylinder", [0, 0, 0, 0, 0, height r, outerDiam/2 r]]
c1 = c1.union[holder]
// Inner main cylinder. Remove it from outer cylinder.
cin = callJava["frink.graphics.VoxelArray", "makeCylinder", [0, 0, topThickness r, 0, 0, height r, innerDiam/2 r]]
c1.remove[cin]
c1.projectX[undef].show["X"]
c1.projectY[undef].show["Y"]
c1.projectZ[undef].show["Z"]
filename = "dropperHolder.obj"
print["Writing $filename..."]
w = new Writer[filename]
w.println[c1.toObjFormat["test", 1/(r mm)]]
w.close[]
println["done."]
Download or view dropperHolder.frink in plain text format
This is a program written in the programming language Frink.
For more information, view the Frink
Documentation or see More Sample Frink Programs.
Alan Eliasen was born 19966 days, 6 hours, 39 minutes ago.